I used it for a while and everything ran fine (CPU still reached 85☌ but that was because the cooling wasn't too good on the laptop).Ī couple of weeks ago my friend suggested that I DDU and reinstall all my drivers, both Chipset and GPU. At first, it was due to the temps being limited to 70☌ which was quickly reached and the CPU started throttling.Īfter looking around a bit I discovered Ryzen Controller and used it to raise my temps to 85☌ which allowed for the CPU to put out some performance. I know this processor isn't all that bad ingame and has decent fps, but mine has been underperforming since the start. Ryzen Controller allows us to save some presets locally so that we can quickly apply the one we need at any time, for example in the image above you can see how there are different configuration levels in which there are two for tests to test which is better than the other and one of low performance and low consumption for when we want to make the most of the computer’s battery and squeeze every possible minute of use.I have a laptop with Ryzen 5 3500U with Vega 8 IGPU with 1GB VRAM. VRM Current : We have a single really interesting value that would be the current that we let reach the VRM of the motherboard of our laptop, it is difficult to calculate this value and know what is the maximum that we must put, since each motherboard is very different and there are some very badly cooled VRMs that can even cause loss of power and others well-cooled that if we put too much we can cause damage to our hardware irreversibly, so it is advisable to be careful with the values we enter in Ryzen Controller because a Great power carries great responsibility. The minimum / maximum frequency of the Infnity Fabric, no matter how hard you try to raise this value above the maximum frequency of the IF, it will not give any results, so for maximum performance we recommend the minimum and maximum as the maximum value of the IF that It is obtained by dividing the speed at which our RAM runs by two, for example if our RAM runs at 2400 MHz, our IF is merging at 1200 MHz maximum and this value cannot be increased.
0 kommentar(er)
